8
CIRCLE FLAMER occupy 6 channels.
Detail information please refer to the table of
page18.
6. Set DMX address
Host controller:
Press”pre-heat” button (light on).
DMX console:
switch DMX value of channel 6 to
50-200.
7. Pressuriser
Reconfirm safety lock located at TEST MODE before
test. In this status, the nozzle will rotate, and igniter
will activated, but there is no flame.
When use DMX console to test the sequence,
suggest to set CH1 at 128, so that nozzle stay at
straight up position after each sequence.
Host controller:
Press “pre-heat” key (light off).
DMX console:
switch DMX value of channel 6 to
0-49/201-255.
8. Check device status
in TEST MODE
9. Pressure Relief
Set DMX Address
1
Host controller:
Press”pre-heat” button (light on).
DMX console:
switch DMX value of channel 6 to
50-200.
11. Pressuriser
Set firing sequence
Host controller:
Press “FIRING” key.
DMX console:
switch DMX value of channel 3 to
254-255.
12. Firing
Relief pressure when show finished or CIRCLE
FLAMER not use for a long period.
Host controller:
Press “pre-heat” key (light off).
DMX console:
switch DMX value of channel 6 to
0-49/201-255.
13. Pressure Relief
Before switch to USER MODE, Please strictly follow
the safety distance requirement, remove all human,
animal or flammable objects in the danger area.
10.Switch safety lock to
USER MODE