18
Ordercode: 43157
X-Terminator
Main Menu Options
Built-in programs
Sound-controlled
Master/Slave
DMX-512
System Settings
1. Built-in Shows
01)
Press the
MODE
button until the display shows
.
02)
Press the
ENTER
button to enter the menu.
03)
Press the UP and DOWN buttons to run one of the built-in shows:
.
04)
Once your preferred show has been chosen, press the
ENTER
button to proceed to
speed settings.
05)
Press the UP and DOWN buttons to adjust the speed of your preferred built-in show:
. The higher the value the faster the speed.
2. Sound-controlled Effect
This effect makes the unit respond to the beats of background music, being intercepted by the built-in
microphone.
01)
Press the
MODE
button until the display shows
.
02)
Press the
ENTER
button to enter the menu.
03)
Press the UP and DOWN buttons to run one of the sound-controlled shows:
.
04)
Turn the control
(11)
on the rear panel to the left or right to, respectively, decrease or increase
sensitivity of the device to background music.
3. Master/Slave Mode
01)
Press the
MODE
button until the display shows
.
02)
Press the
ENTER
button.
will appear on the display.
03)
The laser is now operating in Slave mode and it will react the same as the master device.
4. DMX Mode
With this menu you can set the desired DMX address.
01)
Press the
MODE
button until the display shows
.
02)
Press the
ENTER
button again, the display will show
.
03)
Press the
ENTER
button to enter the DMX Mode menu.
04)
Press UP and DOWN buttons to choose one of the two available DMX modes:
2 channels
11 channels
05)
If the display shows
, press the
ENTER
button to enter the menu.
06)
Press the UP and DOWN buttons to select the DMX address between
.
07)
If the display shows
, press the
ENTER
button to enter the menu.
08)
Press the UP and DOWN buttons to select the DMX address between
.
