7
Installation
Installing the Lamp
The Showtec Gobo Quake uses the ELC 24V 250W (ordercode 80809O / 80809G / 80809P / 80809S)
reflectorbulb as manufactured by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage
! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
1.
Loosen the 6 screws on the back of the housing.
2.
Gently remove the plastic housing.
3.
Read lamp instructions. Do not touch the lamp bulb glass. (See Figure 3.)
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free
towel and rubbing alcohol.).
4.
Insert the lamp pins into the small holes in the lamp socket.
5.
Push the metal housing back and fasten the screws snugly.
Fig. 3
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
The Gobo Quake is a simple plug-&-play device. After you have connected this device, all you have to
do is, turn one of the 2 controls. With the top control you can control the speed, with the bottom control
you can control the Sound activity.
Summary of Contents for Starzone Gobo Quake DMX
Page 1: ...Starzone Gobo Quake DMX ORDERCODE 31322...
Page 17: ......
