7
Installation
Remove all packing materials from the
LED Roto Flower
. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Remove all packing materials from the LED Roto Flower. Check that all foam and plastic padding is
removed.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Control Modes
There are 4 Modes:
1)
Built-in Programs 1-7,
All LEDs ON, Automatic
2)
Sound-controlled
3)
Master/Slave
4)
DMX512
One LED Roto Flower (
Built-in Programs 1-7, All LEDs ON, Automatic
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the LED Roto Flower is not connected by a DMX-cable, it functions as a stand-alone device.
Dipswitch #10 must always be set to ON for manual control.
You can use Dipswitch
#1(Fast) and #2(Slow)
to adjust the speed of each program.
Program 1
: Dipswitch #3 and #10
Program 2
:
Dipswitch #4 and #10
Program 3
:
Dipswitch #3, #4 and #10
Program 4
:
Dipswitch #5 and #10
Program 5
:
Dipswitch #3, #5 and #10
Program 6
:
Dipswitch #4, #5 and #10
Program 7
:
Dipswitch #3, #4, #5 and #10
Speed control
: Dipswitch #1(Fast) and #2(Slow)
