22
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens, follow the directions below to do
so.
1.
Unplug the unit from electric power source.
2.
Insert a flat-head screwdriver into a slot in the fuse cover.
Turn the screwdriver to the left, at the same
time gently push a bit (Turn and Push). The fuse will come out.
3.
Remove the used fuse. If brown or unclear, it is burned out.
4.
Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
1.
If the device does not operate properly, unplug the device.
2.
Check the fuse, power from the wall, all cables etc.
3.
If all of the above appears to be O.K., plug the unit in again.
4.
If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
5.
Return the device to your Showtec dealer.
Summary of Contents for LED Design Par18 RGB
Page 1: ...LED Design Par 18 RGB ORDERCODE 42570...
Page 13: ...11 MENU OVERVIEW 9 channels 3 channels 4 channels...
Page 22: ...20 Beam Angles...
Page 26: ......
