9
Ordercode: 30780
LED Blinder 2 COB
Control Modes
There are 4 modes:
•
Built-in programs
•
Manual Mode
•
Master/Slave
•
DMX-512 (1CH, 2CH, 3CH and 4CH)
One LED Blinder (Built-in programs and Manual Mode)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the LED Blinder is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14 and 15 for more information about the Built-in programs and Manual Mode.
Multiple LED Blinders (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Use a 3-pin XLR cable to connect the LED Blinder.
The pins:
01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 14-15 (Built-in
programs, Color Presets and Manual Mode). This means that you can set your desired operation
mode on the master device and all slave devices will react the same as the master device.
Multiple LED Blinders (Master/Slave control)
Fig. 03
