8
Ordercode: 30780
LED Blinder 2 COB
Backside
Fig. 02
04)
Ground/earth connection
05)
Grey Pro Power connector
06)
5-pin DMX signal connector OUT
07)
3-pin DMX signal connector OUT
08)
Safety Eye
09)
LCD D 3 Menu buttons
10)
5-pin DMX signal connector IN
11)
3-pin DMX signal connector IN
12)
Fuse T3,15AL/250V
13)
Blue Pro Power connector
14)
Ground/earth connection
Installation
Remove all packing materials from the LED Blinder. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
