3
Ordercode: 61000
FX Ice Jet
Before your initial start-up, please make sure that there is no damage caused by transportation. Should
there be any, consult your dealer and do not use the device.
To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to
follow the safety instructions and warning notes written in this manual.
Please consider that damages caused by manual modifications to the device are not subject to
warranty.
This device contains no user-serviceable parts. Refer servicing to qualified technicians only.
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
Never remove warning or informative labels from the unit and, on regular basis, make sure that they
remain clearly visible and legible.
Never place any material over the cannon tube.
Never look directly into the cannon tube.
Never leave any cables lying around.
Do not expose the device to any source of vibration.
Do not insert objects into the cannon tube.
Do not switch the device on and off in short intervals, as this would reduce the device’s life.
Do not touch the device’s housing bare-handed during its operation.
Do not remove or disable the safety devices.
Do not shake the device. Avoid brute force when installing or operating the device.
Use the device ONLY if there ARE NOT ANY people, animals or other objects in the direction of the
output within the output range. The shooting direction is the direction in which the output pipe on
the FX Ice Jet is pointed. The output distance depends on the humidity in the air! The higher the
humidity, the longer the output distance.
Only use the device indoors, avoid contact with water or other liquids.
Only operate the fixture after having checked that the housing is firmly closed and all screws are
tightly fastened.
Only operate the device after having familiarized with its functions.
Avoid flames and do not put close to flammable liquids or gases.
Always keep case closed while operating.
Always allow free air space of at least 50 cm around the unit for ventilation.
Always disconnect power from the mains, when device is not used or before cleaning! Only handle
the power cord by the plug. Never pull out the plug by tugging the power cord.
Make sure that the device is not exposed to extreme heat, moisture or dust.
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that all the required safety devices are in good condition and function properly.
Make sure that the power cord is never crimped or damaged. Check the device and the power
cord from time to time.
If the cannon tube is obviously damaged, it needs to be replaced, so that its functions are not
impaired.
If the device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
For adult use only. Device must be installed out of the reach of children and unauthorized persons.
Never leave the unit running unattended.
Never attempt to bypass the thermostatic switch or fuses.
For replacement use fuses of same type and rating only.
Provide sufficient lighting of the surroundings.
