3
Ordercode: 42771
Flexstrip Set IP44 RGB
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
•
Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
•
Never remove warning or informative labels from the unit.
•
Never use anything to cover the ground contact.
•
Never place any material over the LEDs.
•
Never look directly into the light source.
•
Never leave any cables lying around.
•
Never use the Flexstrip in sealed or hot places.
•
Do not connect this device to a dimmerpack.
•
Do not switch the device on and off in short intervals, as this will reduce the device’s life.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Only use the device indoors, avoid contact with water or other liquids.
•
Only operate the device after having familiarized with its functions.
•
Avoid flames and do not put close to flammable liquids or gases.
•
Always disconnect power from the mains, when device is not used or before cleaning! Only handle
the power cord holding it by the plug. Never pull out the plug by tugging the power cord.
•
Always mount the Flexstrip on aluminum or metal surface, for best heat dissipation.
•
Make sure that the device is not exposed to extreme heat, moisture or dust.
•
Make sure that the available voltage is not higher than stated on the rear panel.
•
Make sure that the power cord is never crimped or damaged. Check the device and the power
cord from time to time.
•
If the LEDs are obviously damaged, it has to be replaced.
•
If device was dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
•
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
•
If your Showtec device fails to work properly, discontinue the use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
•
The user is responsible for correct positioning and operating of the Flexstrip. The manufacturer will not
accept liability for damages caused by the misuse or incorrect installation of this device.
•
This device falls under protection class I. Therefore it is essential to connect the yellow/green
conductor to earth.
•
Repairs, servicing and electric connection must be carried out by a qualified technician.
•
WARRANTY: Till one year after date of purchase.
Summary of Contents for FLEXSTRIP SET IP4RGB
Page 12: ...2016 Showtec...
