21
Ordercode: 42671
Cameleon Flood 15 Q4
Channel 6 – Auto speed (CH5 must be set between 41-255
)
0-255
Speed adjustment, from slow to fast
Channel 7 – Red Dimmer intensity (CH1 must be set between 1-255
)
0-255
Gradual adjustment Red from 0-100%
Channel 8 – Green Dimmer intensity ( CH1 must be set between 1-255
)
0-255
Gradual adjustment Green from 0-100%
Channel 9 – Blue Dimmer intensity (CH1 must be set between 1-255
)
0-255
Gradual adjustment Blue from 0-100%
Channel 10 – White Dimmer intensity (CH1 must be set between 1-255
)
0-255
Gradual adjustment White from 0-100%
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02)
There may not be any deformations on housings, fixations and installation spots.
03)
Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04)
The electric power supply cables must not show any damages or material fatigue.
The Cameleon Flood 15 Q4 requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture’s light-output will be significantly reduced. Disconnect the mains power supply, and
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents.
The front lens will require weekly cleaning, as smoke-fluid tends to build up residues, reducing the light-
output very quickly.
Keep connections clean. Make sure connections are thoroughly dry before linking equipment or
supplying electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the LEDs, the internal fuse.
01)
Power supply. Check that the unit is plugged into an appropriate power supply.
02)
The LEDs. Return the Cameleon Flood to your Showtec dealer.
03)
The internal fuse. Return the Cameleon Flood to your Showtec dealer.
04)
If all of the above appears to be O.K., plug the unit in again.
05)
If you are unable to determine the cause of the problem, do not open the Cameleon Flood, as this
may damage the unit and the warranty will become void.
06)
Return the device to your Showtec dealer.
