SHOWTEC Blacklight Set 120cm, User Manual

Page: 5 / 10

3
•
Always disconnect power from the mains, when device is not used or before cleaning! Only handle
the power-cord by the plug. Never pull out the plug by tugging the power-cord.
•
Make sure that the device is not exposed to extreme heat, moisture or dust.
•
Make sure that the available voltage is not higher than stated on the rear panel.
•
Make sure that the power-cord is never crimped or damaged. Check the device and the power-cord
from time to time.
•
If the external cable is damaged, it has to be replaced by a qualified technician.
•
If the lens or glass is obviously damaged, it has to be replaced. So that its functions are not
impaired, due to cracks or deep scratches.
•
If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
•
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
•
If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
•
For adult use only. Lighteffect must be installed out of the reach of children. Never leave the unit
running unattended.
•
Allow time to cool down, before replacing lamp.
•
This device falls under protection-class II, therefore the electrical connection must be carried out by
a qualified technician
•
During the initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective.
•
Repairs, servicing and electric connection must be carried out by a qualified technician.
•
For replacement use lamps and fuses of same type and rating only.
•
WARRANTY: Till one year after date of purchase.
OPERATING DETERMINATIONS
This device is not designed for permanent operation. Consistent operation breaks will ensure that the device
will serve you for a long time without defects.
The minimum distance between light-output and the illuminated surface must be more than 0,5 meters.
The maximum ambient temperature t
a
= 45°C must never be exceeded.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
If this device is operated in any other way, than the one described in this manual, the product may suffer
damages and the
warranty becomes void.
Any other operation may lead to dangers like short-circuit, burns, electric shock, lamp explosion, crash etc.
You endanger your own safety and the safety of others!
CAUTION ! EYEDAMAGES !.
Avoid looking directly into the light source.
(meant especially for epileptics) !