3
Ordercode: 70237
PLE-30-080 Chainhoist Contoller
●
Cabling should comply with the applicable standards.
●
Decent plugs should be used.
●
All external cabling should be tested on functionality and resistance in Ohms.
●
Failures in cabling and plugs could cause malfunction of the hoist and controllers.
●
We took every precaution to ensure the accuracy of this manual. However, no liability will be
accepted for any errors written in this manual.
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
●
Never let the power-cord come into contact with other cables! Handle the power-cord and all
connections with the mains with particular caution!
●
Never remove warning or informative labels from the unit.
●
Never use anything to cover the ground contact.
●
Never leave any cables lying around.
●
Do not switch the device on and off in short intervals, as this would reduce the device’s life.
●
Do not shake the device. Avoid brute force when installing or operating the device.
●
Avoid contact with water or other liquids.
●
Only operate the fixture after having checked that the housing is firmly closed and all screws are
tightly fastened.
●
Only operate the device after having familiarized with its functions.
●
Avoid flames and do not put close to flammable liquids or gases.
●
Always allow free air space of at least 50 cm on the backside of the unit for ventilation.
●
Always disconnect power from the mains, when device is not used or before cleaning! Only handle
the power-cord by the plug. Never pull out the plug by tugging the power-cord.
●
Make sure that the available voltage is not higher than stated on the rear panel.
●
Make sure that the power-cord is never crimped or damaged. Check the device and the power-
cord from time to time. If the powercord is damaged, return the device to an authorized dealer for
repair.
●
If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
●
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
●
If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
●
For qualified personnel use only. Make sure that the device is installed out of reach of unauthorized
persons. Never leave the unit running unattended.
●
The device must be installed by qualified personal according the national regulations. The
manufacturer will not accept liability for damages caused by the misuse or incorrect installation of
this device.
●
The device must always be properly connected to the Protective Earth.
●
Repairs, servicing and electric connection must be carried out by a qualified technician.
●
WARRANTY: Till two year after date of purchase.
Summary of Contents for 70237
