Showco Laser RGB, Manual

Page: 10 / 17

The machine can display two different patterns at the same time--24 channel version.And
the 2nd pattern can move with the main pattern-17 channel version,Also you can display one
pattern only--14channel version. The function of each channel as following(if the channnel
not mention main pattern or the 2nd pattern, it means this channel has effect for both two
patterns. Such as channel 1,4,11,12).
9
11. DMX512 Operate
2. Preset program mode (include DMX mode)
Press MODE to select work mode on LCD display. Use ENTER to active or close setting.
UP & DOWN to set DMX address code.
Working mode instruction:
ACCMusic Active: Accelerated music active
STDMusic Active: Standard music active
Automatic mode: Auto-mode
DMXAddr: DMX512 mode. Set address code under this mode. OPEN to active DMX
address value setting function. Then use UP & DOWN to select address
code value you need. Press SAVE to save setting and close DMX address
Code setting function.
LCD display memory function: Save setting automatic when you turn off fixture.
3. Computer software control mode
Fixture, there has a switch to select control mode - by computer or inside program:The
fixture has ILDA DB 25 connector so that it can be controlled by computer software. In the
When ILDA DB25F IN connects with QM2000 interfacial card or USB interfacial card, the
lamp will be control by software which installed in the computer. When ILDA DB25F IN
connector's connection port are free, the laser will driver by the inside program, temporality
it can control by music or DMX512 signal.
The control mode switch will check the 4th Pin (InterLock A) and the 17th Pin (
InterLock B) to adjust whether there has computer (with interfacial card) be connected to
fixture. If Pin 4 not be connected to Pin 17, it means there no interfacial card otherwise
there has and the connection port can receive all the signal of laser perform software that
accord with the ILDA standard, such as LD-2000 of Pangolin company.
In the theory, all the signal of laser perform software that accord with the ILDA Db25
standard can control the fixture. But Pin 4 and Pin 17 not be connected in some laser
perform interfacial card. You will need to sold this two pins together at Pin25 signal output
connector or connect Pin4 and Pin 17of the standard Pin 25 signal cable before use.
Note: We have tested that Pangolin Ld2000 (Qm2000 PCI interfacial card) and our
i.Top laser (USB2.0)interfacial card) can work with this fixture well. But you will need to
make changes as above mentioned when you use Mamba Black software ( Easylaser
interfacial card) of MediaLaser company.
www.carlosmendoza.com.mx