9
Ordercode: 30749
Edison Bar E6
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Installing the Lamp
The Showtec Edison Bar E6 uses the following LED bulbs:
– LED Filament Bulb T9, Crossed Filament (300 mm)
– LED Filament Bulb T9, Crossed Filament (225 mm)
– LED Filament Bulb T9, Crossed Filament (185 mm)
– LED Filament Bulb T9, Straight Filament (300 mm)
– LED Filament Bulb T9, Straight Filament (225 mm)
– LED Filament Bulb T9, Straight Filament (185 mm)
– LED Filament Bulb BT180 (6 W)
– LED Filament Bulb BT118 (6 W)
– LED Filament Bulb G200 (6 W)
– LED Filament Bulb PS52 (6 W)
– LED Filament Bulb PS35 (6 W)
– LED Filament Bulb BTT80 (6 W)
– LED Filament Bulb R160 (6 W)
Use only the appropriate lamp for your unit. Note that product versions that use other lamps, may be
offered in the future. Check your product specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps of higher wattage! Lamps of higher wattage generate temperatures which the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
01)
Disconnect the Edison from power before installing the lamp.
02)
Remove the lamp from the box and hold it by the base. Read lamp instructions. If you touch the bulb
glass, wipe it off with a clean, lint free towel and rubbing alcohol.
03)
Insert the lamp into the housing and turn it clockwise to secure it in position.
Fig. 03
Summary of Contents for Edison Bar E6
Page 21: ...20 Ordercode 30749 Edison Bar E6 Dimensions ...
Page 22: ...21 Ordercode 30749 Edison Bar E6 Notes ...
Page 23: ...22 Ordercode 30749 Edison Bar E6 ...
Page 24: ... 2019 Showtec ...
