Show Tec Edison Bar E6, Manual

Page: 11 / 24

10
Ordercode: 30749
Edison Bar E6
Control Modes
There are 5 modes:
● Auto
● Manual
● Sound-controlled
● Master/Slave
● DMX-512 (1CH, 6CH)
One Edison (Auto and Manual)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Edison is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 15 for more information about Auto mode and Manual mode.
One Edison (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Turn on the music. If the device is set to sound-control, then the Edison will react to the beat of the
music. Please see page 15 for more information about the sound-control options.
Multiple Edisons (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Edison.
The pins: 01) Earth
02) Signal -
03) Signal +
04) Link the units as shown in Fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third and fourth units.
You can use the same functions on the master device as described on page 15 (Auto or Sound-
controlled mode). This means that you can set your desired operation mode on the master device
and all slave devices will react the same as the master device.
Multiple Edisons (Master/Slave control)
Fig. 04