Show Tec Edison Bar E6, Manual

Page: 12 / 24

11
Ordercode: 30749
Edison Bar E6
Multiple Edisons (DMX Control)
01)
Fasten the effect light to a firm trussing or mount it on flat surface. Leave at least 0,5 meter on all
sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin DMX cable to connect the Edison and other devices.
04)
Link the units as shown in Fig. 05. Connect a light controller to the first unit's DMX "in" socket, using a
DMX cable. Connect the first unit’s "out" socket with the second unit's "in" socket, using a DMX
cable. Repeat this process to link the rest of the units.
05) Supply electric power: Plug electric mains power cords into each unit's pro power IN socket, then
plug the other end of the mains power cord into proper electric power supply sockets, starting with
the first unit. Do not supply power before the whole system is set up and connected properly.
Fig. 05
Note : Link all cables before connecting electric power