Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028
www.shorestation.com
0004405
Page 5 of 12
Rev B 11/05/2013
Route the cable down and around the pulley on the
platform weldment.
Run the cable across the bottom side of the platform
and over the pulley next to the winch post extrusion.
Thread down along the extrusion and thru the holes in
the lower frame weldment and secure on the bottom
side with a 3/8” flat washer and two (2) 3/8” hex nuts.
Mount the winch mounting plate to the winch
assembly using three (3) 3/8” X 1” hex bolts. Place
a 3/8” flat washer on each of the three (3) 3/8” X 1”
bolts. Insert the bolts into the slots of the winch
base. Align with the mounting holes in the winch
mounting
bracket. Secure with 3/8” flange lock nuts.
Manual winch assembly is shown on next page.
Mount the winch assembly with winch mounting
bracket to the winch post extrusion using the four
(4) 3/8” X 3-3/4” hex bolts just installed. Place a 3/8”
flat washer on each of
the four (4) 3/8” X 3-3/4” hex
bolts. Insert them into the holes provided in the top
of the winch
post extrusion. Secure with 3/8” flange
lock nuts.
