{17}
Shor-Line | 800.444.1579 |
www.shor-line.com
Step
2
Lay the Back Panel on a flat surface with the inside of the panel facing up. See Fig. 11 below.
Step 3
For the top brackets, use a measuring tape to measure down two inches from the top of the Back Panel. Insert a
#12x1
"
TEK HX HD screw in both holes to secure.
Step 4
For the bottom brackets, use a measuring tape to measure up two inches from the bottom of the Back Panel.
Insert a #12x1
"
TEK HX HD screw in both holes to secure.
notE:
The side of the bracket should be flush with the edge of the Back Panel.
Step
5
Place the Back Panel on the back of the Kennel Assembly with the PVC panel and brackets facing the inside of
the kennel. See Fig. 12 below.
Step 6
Using the #12x1" TEK HX HD screws, attach the Back Panel to the Side Panels. Make sure the panels are flush and
screws are placed in all 4 pre-drilled holes on the brackets.
PLACE BRACKETS 2" DOWN FROM
TOP AND FLUSH WITH THE SIDE.
PLACE BRACKETS 2" UP FROM THE
BOTTOM AND FLUSH WITH THE SIDE.
Fig. 11
A
DETAIL A
Fig. 12
