Questions? Visit Shop-Vac® at www.shopvac.com or call 1-888-822-4644
3
1. Pull lid latches in an outward motion, remove tank cover and any accessories that may have been shipped in the tank.
2. Attach tool holder following the instructions and illustrations in this manual.
3. Before replacing tank cover, refer to Filter Installation or Wet Pick-Up Operation in this manual to ensure you have the proper filters installed for your
cleaning operation.
4. Replace tank cover, and apply pressure with thumb to each latch until it snaps tightly in place. Make sure all lid latches are clamped securely.
5. Insert long machine hose end with locking-nut into inlet of tank and tighten. Do not over-tighten.
6. Attach the extension wands to the accessory end of the hose. Twist slightly to tighten the connection
(Figure A)
.
7. Attach one of the cleaning accessories (depending on your cleaning requirements) on the extension wands. Twist slightly to tighten the connection
(Figure A)
.
8. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
NOTE:
Many more useful tools are available at your local dealer or Shop-Vac
®
website.
UNPACKING AND SET-UP
A
B
C
Assemble as follows:
10. With cord disconnected from receptacle and tank cover removed, turn tank upside down so that the bottom is facing up.
11. With tank drain facing you, take caster feet marked
with letter A and place in slots on left front and right rear
of tank also marked with the letter A
(Figure 1)
.
A
A
A
A
12. Secure with screws provided
(Figure 2)
.
B
1
2
CASTER ASSEMBLY
13. Take caster feet marked with the letter B and place on
right front and left rear of tank also marked with the letter
B
(Figure 3)
.
B
B
B
B
A
A
14. Secure with screws provided
(Figure 4)
.
3
4
15. Insert casters into feet by placing stem of caster into
holes provided. Apply pressure and twisting motion until
casters snap into place
(Figure 5)
.
5
16. Return tank to upright position.
9. You will find four caster feet
(Figure B)
, four casters
(Figure C)
, and four screws with your wet/dry vacuum.
TOOL HOLDER ASSEMBLY
17. With rear of unit facing you, take tool holder and posi-
tion it with tabs facing rear of unit
(Figure 6)
.
18. Place “J” shaped tabs into the slots on cord wraps
(Figure 7)
. Press down until tabs snap into place.
6
7
19. Press down on center of tool holder until tab latches on
bottom of lid
(Figure 8)
.
8
(Not standard with all models)
