-29-
Model W1852 (For Machines Mfd. Since 11/17)
O
PE
R
ATIO
NS
Headstock Faceplate
To.install.faceplate,.do.these.steps:
1.
DISCONNECT
MACHINE FROM POWER!
2..
Insert indexing pin into an indexing hole and rotate
spindle until pin engages to prevent spindle from
turning while you tighten faceplate, as shown in
Figure.26
.
3..
Thread faceplate onto spindle until it is snug.
4.
Tighten two set screws along inside diameter of
faceplate to secure it to spindle (see
Figure.26
).
Note:.
To remove faceplate, disconnect lathe from
power source and perform steps above in reverse.
Installing.Faceplate
Figure.26.
Locking spindle with indexing
pin and faceplate set screw.
Faceplate Set
Screw (1 of 2)
Indexing Pin
To. prevent. faceplate. and. workpiece.
separating. from. spindle. during.
operation,. headstock. faceplate. MUST.
be. firmly. threaded. onto. spindle. and.
secured. in. place. by. fully. tightening.
the. two. faceplate. set. screws.. If.
these. instructions. are. not. properly.
performed,. serious. personal. injury.
could.occur.
Tool.Needed.
Qty
Hex Wrench 4mm ...............................................1
Summary of Contents for W1852
Page 53: ...Model W1852 For Machines Mfd Since 11 17...
Page 56: ......
