-19-
Model W1852 (For Machines Mfd. Since 11/17)
SE
TU
P
Assembly
Before beginning the assembly process, refer to
Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run
.
To.assemble.machine,.do.these.steps:
1..
Position stand legs upright approximately 58" apart,
and get them reasonably aligned (see
Figure.10
).
Figure.11.
Lathe assembly secured to
stand legs
x 8
Figure.10.
Stand legs aligned and centers
of legs positioned 58" apart.
58"
2..
With help from two assistants, or using a fork lift
and lifting straps, carefully position lathe assembly
on top of stands/legs and align mounting holes.
3..
Secure lathe assembly to stand legs with (8) M10-1.5
x 35 cap screws and 10mm lock washers, as shown in
Figure.11
.
Figure.12.
Leg supported for feet
installation.
Support Block
4..
If bolting lathe to floor, skip to
Step.7
. Otherwise,
move tailstock, tool rest assembly, and headstock
to one end of lathe bed way (refer to
Operations
,
beginning on
Page.22
).
5..
Use assistants to lift one end of lathe onto support
block and stabilize lathe in preparation for installing
machine feet (see
Figure.12
).
Summary of Contents for W1852
Page 53: ...Model W1852 For Machines Mfd Since 11 17...
Page 56: ......
