Shop fox W1852, Owner'S Manual

Page: 23 / 56

-21-
Model W1852 (For Machines Mfd. Since 11/17)
SE
TU
P
Test.Run
Serious. injury. or. death. can. result.
from. using. this. machine. BEFORE.
understanding. its. controls. and. related.
safety.information..DO.NOT.operate,.or.
allow.others.to.operate,.machine.until.
the.information.is.understood..
DO. NOT. start. machine. until. all.
preceding.setup.instructions.have.been.
performed..Operating.an.improperly.set.
up. machine. may. result. in. malfunction.
or. unexpected. results. that. can. lead.
to. serious. injury,. death,. or. machine/
property.damage.
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from power,
and fix the problem BEFORE operating the machine again.
The
Troubleshooting
table in the
SERVICE
section of this
manual can help.
To.test.run.the.machine,.do.these.steps:
1.
Clear all setup tools away from machine.
2.
Connect machine to power supply.
3.
Set spindle direction switch to neutral or "O"
position and turn speed control knob all the way
counterclockwise.
4.
Squeeze tab on bottom of Emergency Stop button,
lift button to open switch cover, and press green ON
button to start machine.
5.
Verify machine is operating correctly by turning
spindle direction switch to "R" position, then slowly
turn speed control knob to the right.
—
.
When operating correctly, machine runs smoothly
with little or no vibration or rubbing noises.
— Investigate and correct strange or unusual noises or
vibrations before operating machine further. Always
disconnect machine from power when investigating
or correcting potential problems.
6.
Turn speed control knob all the way left.
7.
Turn spindle direction switch to "L" position, and
slowly turn speed control knob to the right.
—
.
When operating correctly, machine runs smoothly
with little or no vibration or rubbing noises.
8.
Move spindle direction switch to "O" position, and
push in Emergency Stop button.
9.
Without opening Emergency Stop
button, turn spindle direction switch
to "R" and "L" positions. Machine
should not start at either position.
— If machine does not start, Emergency
Stop button safety feature is working
correctly. Test run is complete.
— If machine does start (with Emergency
Stop button pushed in), immedi-
ately disconnect power to machine.
Emergency Stop button safety fea-
ture is not working correctly. This
safety feature must work properly
before proceeding with regular oper-
ations. Call Tech Support for help.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety
disabling mechanism on the switch works correctly.