-21-
Model W1850 (For Machines Mfd. Since 06/17)
SE
TU
P
Figure.24.
Removing switch key from
toggle switch.
Test.Run
Serious. injury. or. death. can. result.
from. using. this. machine. BEFORE.
understanding. its. controls. and. related.
safety.information..DO.NOT.operate,.or.
allow.others.to.operate,.machine.until.
the.information.is.understood..
DO. NOT. start. machine. until. all.
preceding.setup.instructions.have.been.
performed..Operating.an.improperly.set.
up. machine. may. result. in. malfunction.
or. unexpected. results. that. can. lead.
to. serious. injury,. death,. or. machine/
property.damage.
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from power,
and fix the problem BEFORE operating the machine again.
The
Troubleshooting
table in the
SERVICE
section of this
manual can help.
To.test.run.machine,.do.these.steps:
1.
Clear all setup tools away from machine.
2. Before connecting power, spin sanding disc by hand
to check sanding belt tracking.
— If sanding belt tracks straight, proceed to
Step 4.
— If sanding belt does not track straight, refer
to
Sanding Belt Tracking on Page 28 to make
adjustments before proceeding to
Step 3.
3.
Connect machine to power source.
4.
Verify that machine is operating correctly by turning
machine
ON
.
— If sanding belt tracks incorrectly, immediately
turn machine
OFF
to avoid damage to belt. Refer
to
Sanding Belt Tracking on Page 28 to make
adjustments.
— When operating correctly, machine runs smoothly
with little or no vibration or rubbing noises.
— Investigate and correct strange or unusual noises
or vibrations before operating machine further.
Always disconnect machine from power when
investigating or correcting potential problems.
5.
Turn machine
OFF
.
6.
Remove switch disabling key, as shown in
Figure.24
.
7.
Flip toggle switch to
ON
position.
— If the machine does not start, the
switch disabling feature is working
as designed.
— If the machine does start,
immediately stop machine. The
switch disabling feature is not
working correctly. This safety
feature must work properly before
proceeding with regular operations.
Call Tech Support for help.
