-19-
Model W1850 (For Machines Mfd. Since 06/17)
SE
TU
P
16.
Secure disc sander dust port, as shown in
Figure.18,
with (1) M6-1 x 12 Phillips head screw and 6mm flat
washer.
Note:.
Make sure the dust port covers the entire
opening in the dust cover.
17.
Position disc table square to sanding disc (refer to
Squaring.Disc.Table.
on
Page.29
).
Figure.18.
Disc dust port installed.
Figure.20.
Sanding belt table installed.
Figure.21.
Sanding belt support.
18.
Loosen Phillips head screw and align scale
indicator with the "0" mark on table angle scale
(see
Figure.19
). Re-tighten screw.
19.
Install belt table with a
1
⁄
16
" maximum clearance
from sanding belt, and secure it in place using table
lock handle (see
Figure.20
).
20.
Loosen belt-support bracket cap screw shown in
Figure.21
, adjust support bracket approximately
1
⁄
16
" away from the sanding belt, then re-tighten cap
screw.
Figure.19.
Sanding disc table angle scale
pointer installed.
Cap
Screw
Dust
Port
Scale
Indicator
Table Lock
Handle
Belt
Support
Bracket
1
⁄
16
" Maximum Gap
Approximately
1
⁄
16
" Gap
Sanding
Belt
