-45-
Model W1745W (For Machines Mfd. Since 9/16)
SE
RV
IC
E
Calibrating Depth-of-Cut
Scale
The depth scale on the infeed table can be calibrated or
"zeroed" if it is not correct.
Tools Needed
Qty
Straightedge 24" ................................................1
Phillips Head Screwdriver ......................................1
Open-End Wrench 13mm .......................................1
Hex Wrench 4mm ...............................................1
To calibrate the depth scale, do these steps:
1.
DISCONNECT MACHINE FROM POWER!
2.
Set outfeed table height as described in
Setting
Outfeed Table Height
on
Page 25
.
3.
Move cutterhead guard out of the way, and place a
straightedge across infeed and outfeed tables.
4.
Loosen upper jam nut and upper stop screw to
prevent obstruction of infeed table movement. (see
Figure 71
).
5.
Place straightedge across infeed and outfeed tables.
6.
Adjust infeed table until it is level with outfeed table,
as illustrated in
Figure 72
.
7.
Loosen Phillips head screw and adjust depth scale
indicator exactly to “0” (see
Figure 73
).
8.
Reposition upper stop screw against stop pin, and
tighten jam nut to secure in place.
Figure 73
. Depth-of-cut pointer
adjusted to "0" position.
Depth Scale at
"0" Position
Figure 71
. Location of upper jam nut and
stop screw.
Upper Jam
Nut
Upper Stop
Screw
Straightedge
Outfeed
Infeed
Figure 72
. Using a straightedge to align
outfeed table height with knife at TDC.
