-17-
Model W1745W (For Machines Mfd. Since 9/16)
SE
TU
P
Assembly
7.
Remove access panel from rear of cabinet.
8.
With help from assistants, lift jointer onto cabinet,
and align all three mounting holes between jointer
and cabinet (see
Figure 11
).
9.
Attach jointer to cabinet using (3) M10-1.5 x 16 hex
studs, (3) 10mm flat washers, (3) 10mm lock washers.
Note:
Reach through the dust chute to access
forward mounting hole.
Before beginning the assembly process make sure you
have all items listed in "
Items Need for Setup
," and all
parts with export grease have been cleaned. Complete all
steps in the assembly procedure prior to performing the
Test Run
on
Page 26
.
To assemble jointer, do these steps:
1.
Lay cabinet on its side and install leveling feet, as
shown in
Figure 9
.
Figure 9.
Installing leveling feet into
bottom of cabinet.
2.
Attach foot pedal assembly to cross brace at bottom
of cabinet with (3) M8-1.25 x 55 cap screws, (6)
8mm flat washers, (3) 8mm lock washers, and (3)
M8-1.25 hex nuts, as shown in
Figure 10
.
3.
Turn cabinet upright.
4.
Test foot pedal by pressing downward on foot pedal
assembly; jointer should move freely.
5.
Place both hands on cabinet and release foot pedal
to lower cabinet to floor.
6.
Level cabinet front-to-back and side-to-side by
adjusting leveling feet.
Leveling
Feet
The jointer assembly weighs
approximately 200lbs.
Get
assistance from at least 2 helpers
when lifting jointer onto cabinet.
Continued on next page
Figure 10.
Locking foot pedal attached to
cabinet.
x 3
Figure 11.
Location of mounting holes.
Access
Panel
Removed
Mounting
Holes
Dust Chute
