-20-
Model W1669/W1670 (For Machines Mfd. Since 04/18)
SE
TU
P
Assembly
Before beginning the assembly process, refer to
Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run
.
The W1669 comes with one geared table bracket. The
W1670 comes with a geared table bracket and a table
support arm, which allows the distance between the
column and table to be adjusted. The table bracket and
support parts are not interchangeable between models.
To assemble the drill press, do these steps:
1.
Place the column on the base and align the mounting
holes.
2.
Secure the column to the base with the four hex
bolts, as shown in
Figure.11
.
3.
Insert the table lock lever through the un-threaded
hole (see
Figure
12
) in the table bracket, and then
tighten the lever into the threaded side exactly
three turns.
4.
Starting with the pinion gear, insert the shaft into
the table bracket and mesh the teeth with the worm
gear as shown in
Figure
12
.
5.
Align the set screw in the crank handle with the flat
pad on pinion shaft.
6.
Tighten the 3mm set screw to lock the handle in
place (see
Figure
13
).
7..
Examine the rack and note that the rack teeth at
one end are cut closer to the end of the rack than
the other.
Figure.11..
Column secured to base.
Figure.12..
Installing pinion into worm
gear.
Figure.13..
Aligning set screw with flat pad
on pinion.
Set
Screw
Flat
Pad
Unthreaded
Hole
Worm
Gear
Pinion
Gear
