23
22
When installing the intercom, remove the intercom base
covers. As to the battery, place it into the battery space at
the rear bottom of the helmet.
For installing and removing the intercom, please refer to
the instruction manual of the intercom you use.
Removing Intercom Base Cover
Insert the service tool in the gap between the intercom
base and the cover with pushing the tab and slide the
cover down along the side line of the face cover in the
direction of the arrow shown. Sliding the cover directly
below may damage the base.
When Installing the Intercom
Removing the Battery Space Cover
Lift up the battery space cover pushing the tab in the
direction of the arrow in the drawing. After removing the
cover, remove the cushioning material from the space.
Installing the Intercom Base Cover
1. Align the upper side of the cover with the base line
on the base (Drawing 1).
2. Slide the cover up onto the base in the direction of
the arrow shown (Drawing 2).
Installing the Battery Space Cover
Insert the hooks (3 points) of the battery space cover into
the fixed holes of the battery housing until they click into
position.
WARNING
z
z
When the intercom is not installed to the helmet,
be sure to use the helmet with the intercom base
covers and the battery space cover equipped.
z
z
Be sure to use SHOEI recommended intercom
exclusively designed for NEOTEC II. For
i n f o r m a t i o n a b o u t S H O E I r e c o m m e n d e d
intercoms, please refer to SHOEI official website.
z
z
For information about handling the intercom, please
refer to the instruction manual of the intercom you
use.
1
2
Intercom Base
Cover
Tab
Tab
Battery Space
Cover
Battery Space Cover
Service
Tool
Base Line
Intercom
Upper side of cover
Intercom
Base Cover
Intercom Base
Cover
Front
Rear
Hole
Hole
Tab
WARNING
zz
Before use, check that the shield/visor hooks and
gears are fit firmly.
zz
Be sure to always wear the center pad, cheek
pads, and chinstrap covers when using the helmet.
zz
When cleaning and caring for the helmet and
shield/visor, do not use any of the following
cleaning materials: hot water over 40ºC; salt water;
any acidic or alkali detergent; benzine, thinner,
gasoline, or other organic solvents; glass cleaner;
or any cleaner containing organic solvents. If any
of these cleaners are used, the helmet’s chemical
nature may be altered and safety may be hindered.
zz
If insects become stuck to the helmet during riding
and are left in place, the helmet surface may be
corroded. They should be removed promptly.
zz
Be sure to use SHOEI genuine parts when
replacing the shield/visor, sun visor, or inner parts.
These optional parts are available for repair or
replacement.
To replace the parts, read the instruction manual that
comes packed with the parts.
zz
CNS-3 Shield/Visor
zz
QSV-1 Sun Visor
zz
PINLOCK
®
EVO lens (DKS301)
zz
Chin Curtain
zz
Breath Guard
zz
Face Cover
zz
Face Cover Screws (2)
zz
Face Cover Washers, right and left
zz
Upper Air Intake
zz
Top Air Outlet
zz
Center Pad
zz
Cheek Pads (right and left)
zz
Chinstrap Covers (right and left)
zz
Ear Pads (right and left)
Parts List
Learn more about motorcycle helmets we have.