SETTING SHOCK PRESSURE
9
OPERA
TIONS AND SER
VICE MANU
AL
SETTING SHOCK PRESSURE
To get the best performance out of your SHOCKWAVE Seat, it is important to properly adjust the air pressure on the FOX
Float H2O shock absorber. This seat can be adjusted for optimum performance of varying payloads and sea conditions.
Do not adjust air pressure of an occupied seat.
150 lbs./68 kg.
70 PSI
85 PSI
100 PSI
200 lbs./90 kg.
250 lbs./113 kg.
SHOCKWAVE RECOMMENDED SETUP STARTING PRESSURES
Occupant Weight
Shock Pressure
To set your seat:
1. Remove the air fill cap on the valve located at the top of the seat and attached the SHOCKWAVE pump.
2. If your seat is equipped with a Protune system, ensure the selector switch is set to soft.
3. Inflate the unoccupied seat to the starting pressure shown below.
4. Sit in the seat, bounce a few times, and stay seated to establish your current ride height.
5. Ensure the arrow on the carriage (or seat) is within the green zone of the ride height indicator decal.
IMPORTANT
For rough seas the arrow on the carriage (or seat) should be at the top of the green zone of the decal located on
the seat frame when the seat is occupied. For calm seas the arrow can be towards the bottom of the green zone.
DANGER
Do not allow shock to bottom out - serious injury can result - warranty is void if shock bottoms out.
