14
This document is written and published by ShockWatch, Inc. All rights reserved. No Portion of this document
may be copied, reproduced or transcribed without express consent of ShockWatch. ShockWatch reserves the
right to change this document and its products. Every effort has be made to ensure accuracy in content.
PRODUCT MANUAL
Stop a trip by pressing and holding Button A until the all
three LEDs are solid then release Button A. The On and
Alarm LEDs will flash multiple times while Button A is held.
After Button A is released, the sending LED will illuminate
solid or flash as the device sends a trip stop message to the
SpotSee platform.
The reason you need to hold the button to stop the trip is to prevent people from stopping
the trip while in transit with a simple push of the button. This way, stopping the trip is
a deliberate action. Also, as long as there is cellular coverage notice will be sent to the
SpotSee user if the trip has been stopped or the device has been reset, so you know
immediately if someone has tampered with the device.
If you stop a trip while the Spotbot is transmitting a message, both On and Alarm LEDs will
go solid and Sending will keep flashing.
• When replacing the batteries make sure you have all you need on hand. The SpotBot will
keep settings for 5 min without batteries so you can swap batteries.
• If the device goes longer than 5 min without batteries, or if the SpotBot’s batteries become
depleted during a trip, you must repeat step
3. Configure your SpotBot.
• The SpotBot will not start a Trip without the correct settings, please refer to step
4. How
to use your SpotBot, a. Start a Trip,
for more information.
• If you want to change SpotBot settings for a new Trip please refer to step
3. Configure
your SpotBot.
The SpotSee Platform enables you to monitor and control your assets from any location.
B. STOP A TRIP
C. OTHER INFORMATION ABOUT BATTERIES AND SETTINGS
Summary of Contents for SpotBot Cellular
Page 1: ...PRODUCT MANUAL ...
