PRODUCT MANUAL
2. INITIAL SETUP
4
This document is written and published by ShockWatch, Inc. All rights reserved. No Portion of this document
may be copied, reproduced or transcribed without express consent of ShockWatch. ShockWatch reserves the
right to change this document and its products. Every effort has be made to ensure accuracy in content.
First, familiarize yourself with your new SpotBot. On the front of the device you will see 3
LED indicators, 2 buttons and a USB port.
Remove the battery cover at the bottom of the SpotBot. Place the batteries in the correct
position. Once the batteries are inserted properly, close the battery compartment and
make sure the screws are tight without applying excessive force.
Left LED (ON)
Indicates if a trip is started/stopped. A trip is started when the LED flashes once per
minute. This LED will be yellow when battery power is low.
Middle LED (ALARM)
Red LED indicates that an alarm impact has been detected.
Right LED (SENDING)
Green LED flashes when the unit is sending data to the SpotSee Cloud.
Button A
Enables start and stop of a Trip.
Button B
This recessed button will delete all data in the SpotBot (insert a pin in the hole to access
the button).
USB Port
To connect the SpotBot to a computer for configuration and download, via micro USB cable.
Included with your SpotBot are 5 no tamper stickers for your use.
We recommend you use the stickers over the rubber cover as an added guarantee that no one will
tamper with the SpotBot during a trip.
Green LED
Trip on/off
Button A
Start/stop
Button B
Clear trip data
USB Port
Green LED
Unit transmitting
Red LED
Alarm Detected
Summary of Contents for SpotBot Cellular
Page 1: ...PRODUCT MANUAL ...
