Shively Labs 6822, Instruction Manual Installation, Operation, & Maintenance, Page: 24 / 78

Bay Assembly
16
Figure 13. Bay arm attachment
Attach the bay cable
(single-bay antenna
only)
NOTE
If your antenna has more than one bay, skip this section and go on to
Attach the feedstraps to the endseal.
a. Attach the angled connector of the bay cable section ( Figure 14 on page 17,
8 ) to the base of the endseal ( 9 ).
b. Pass the cable under the arm saddle to the mount end of the weldment.
Secure it firmly to the weldment, using tie-wraps ( 44 ).
Attach the feedstraps
to the endseal.
NOTE
The feedstraps are shipped in place on the dipole arms.
a. Remove the wingnut and washers from the endseal ( Figure 14 , 9 ) (the white
plastic dome on the antenna weldment).
CAUTION
Do NOT move the feedstrap clips on the sliding V-arms. The antenna
was tuned with the clips in place. If you move them, the antenna will not
work as expected.
b. Loosen the feedstrap clip hardware ( 10 )
just enough
to swing the feedstraps
( 11 ) into place over the endseal.
c. Place the slots in the feedstraps over the endseal stud and reinstall the
endseal washers and the wingnut. Be sure to reinstall the brass washer ( 12 )
as shown. Tighten the wingnut.