19
RS-232 & ETHERNET SERIAL INTERFACE
RS-232 SERIAL INTERFACE CONNECT a PC or CONTROL SYSTEM. VERSION COMPATIBLE V2.0.1
For a complete list of commands, please reference external document extended RS-232 Protocol Instruction Manual.
Example of the commanded string to route Input 3 to Output 4:
OUTPUT04 03;
RS-232 CONFIGURATION
RS-232 cable is a straight thru cable and not null-modem
Definition
Pin
Pin
Definition
1
1
DCD
TX
2
2
RX
RX
3
3
TX
4
4
DTR
GND
5
5
GND
6
6
DSR
7
7
RTS
8
8
CTS
9
9
RI
RS-232 SERIAL INTERFACE PROTOCOL COMMANDS (Ethernet / RS-232 Control driver V2.0)
The Shinybow switcher can be controlled via the RS-232 serial control port to allow for interfacing to a PC, or similar third party control
system.
The serial communication parameters are 9600 baud, 8 bit, No Parity and 1 stop bit - this is often referred to as 9600 8N1.When the unit
recognises a complete command it will perform the requested action - there is no delimiter character required.
ETHERNET SERIAL INTERFACE CONNECT a PC or CONTROL SYSTEM. VERSION COMPATIBLE V2.0
For a complete list of commands, please reference external document
extended Ethernet Protocol Instruction Manual.
Example of the commanded string to route Input 3 to Output 4
OUTPUT04 03;
ETHERNET TCP/IP PROTOCOL COMMANDS
(Ethernet / RS-232 Control driver V2.0.1)
*** The Ethernet port and RS-232 port
cannot
be used simultaneously.
Any connection to the Ethernet Control port will disable serial
commands send to the RS-232 port.***
ETHERNET SERIAL INTERFACE
Pin Ethernet Reference
1
TXOP
TX +
2
TXON
TX -
3
RXIP
RX +
4
NC
5
NC
6
RXIN
RX -
7
NC
8
GND
Note :
Control the switcher
SPD : Speed
LINK : Ethernet link
RJ-45 Female 8P-8 Connector
SB Device
PC
