Shindaiwa DGK15FU, Owner'S And Operator'S Manual, Page: 42 / 110

39
Close the drain valve lever after the liquid has been flushed, and applies sealant coating
to the plug or wraps it by seal tape.
(10) Spill Containment Cleaning/Inspection
WARNING : INJURY
Do not lift up the unit using tie downs. Use of such could result in the generator falling.
No persons should be under a lifted generator at all the time.
CAUTION : INJURY
Always be sure to use lifting hooks when lifting up the generator, and raise it
slowly at a completely vertical angle.
Personnel performing lifting work must wear protective gear such as helmets,
safety shoes and gloves.
Do not move the generator during operation.
Clean Every 400 hours or 1 year
Separate the spill containment from this generator to clean and inspect the spill containment.
Spill Containment Separate/Reassemble
Disconnect the wiring connector.
Remove the seven spill containment fixing bolts (M8, 7 pieces).
Lift the generator, separate the spill containment and set the generator on a flat surface.
After cleaning and inspecting the inside of the spill containment, reverse the procedure
above for re-assembly.
Reassemble the fuel piping and wiring connector to their original positions.
< Note >
Do not operate the generator while separating.
3
2
3
4
Drain Valve
Drain Plug
(R1/2)
Loosen
Tighten
Close
Close
Open
Drain Valve
Drain Valve
Lever
Drain Plug(R1/2)
Drain Valve Lever
5
1