Shindaiwa DGK15FL, Owner'S And Operator'S Manual

Page: 27 / 54

24
8-1. Checking Engine Oil
To check the engine oil, keep the equipment in leveled position, remove the oil level gauge
and wipe so that no oil remains, and then re-insert the dipstick fully. Prior to starting the
engine, make sure to fill the engine oil through the oil filler until it reaches the MAX. line.
< Note >
 Wait approximately five minutes or more after stopping the engine or adding oil before
checking the oil level again.
 An accurate oil level reading cannot be obtained if the generator is not placed in leveled
position.
 Do not overfill with oil to avoid engine damage.
(1) Types of Engine Oil
Use only API service-type
CF
class.
(2) Engine Oil Viscosity Grades
Use a diesel engine oil with an appropriate viscosity corresponding to the ambient
temperature (refer to the table).
WARNING : INJURY
 Always turn the starter switch to the STOP position and stop the engine, then close
and lock OPERATION PANEL DOOR before checking or maintaining the engine or
any equipment.
 Do not open the check door when the starter switch is in the AUTO or START
position. It may get caught in rotating parts such as cooling fans and fan belts.
CAUTION : BURNS
 Do not touch the engine and surrounding components immediately after stopping the
engine as they are still extremely hot.
CAUTION : FIRE
 Always be sure to wipe up any spilled fuel or oil.
8. Pre-Operation Inspection
OK
Not
Enough
Too
Much
Oil Level
Gauge
MIN MAX
Oil Level
Gauge
Oil Filler