Shindaiwa DGK15F, Owner'S And Operator'S Manual

Page: 19 / 52

16
Switches
(1) Starter Switch
The engine warms up and starts automatically.

START
The engine starts automatically.

STOP
The engine is stopped, and the power
supply is turned off completely in this
position. You can also operate the
accessory switch in this position.

AUTO
The engine is started in this position when the remote start terminal closes.
(2) Accessory Switch
If you select "ON," the display turns on, and you can check the fuel gauge.
< Note >
 Set the STARTER SWITCH selector to "STOP" to activate this function.
 Do not leave the accessory switch in the "ON" position. This is to prevent the battery from drain
out.
(3) Breaker
This switch is for transmitting electrical power to the load side. Turn to ON position to output
voltage to the output terminals. Output to the load side is cut off when there is a short circuit
or overload on the load side.
< Note >
 Do not turn off/on the breaker manually to operate or stop a load.
(4) Breaker Trip Selector Switch
This switch is for selecting the tripping order of the three-phase and single-phase breaker
when there is a short circuit or overload on the load side. If the three-phase or single-phase
breaker is selected for precedence in tripping, the selected breaker will trip first when the
total generator output exceeds the rated capacity.
After that, the other breaker will also trip if the generator output exceeds the rated capacity
again.
 Switch Selection

“3


1

”: The three-phase breaker trips first followed by the single-phase breaker.

“Simultaneous (3


1

)
”: The three-phase and single-phase breakers trip
simultaneously.

“1


3

”: The single-phase breaker trips first followed by the three-phase breaker.
(5) Ammeter Selector Switch
This switch is for selecting the output current indicated by the ammeter. Change the switch to
display the following output terminal current on the ammeter.
Starter Switch
Pre-Heating
Indicator
1-Phase
Accessory Switch
Remote Start
Terminal