Shindaiwa DGK15F, Owner'S And Operator'S Manual

Page: 17 / 52

14
If the liquid stored in the spill containment exceeds approximately about 13.7gal. ( 51.7
liters )
during operation, the SPILL CONTAINMENT overflow warning indicator illuminates,
and the engine automatically stops. In that case, open the CHECK DOOR and check inside
the SPILL CONTAINMENT whether fuel and oil leak. If so, flush the liquid stored in the spill
containment after repairing the leaking spot.
(Refer to section “
10. Inspection/Maintenance (9) Flushing Liquid in Spill Containment ”.)
< Note >
 Although the fluids that can leak internally consist of oil, fuel
and coolant, the spill containment does not have a function
that can separate rainwater that has leaked into the
equipment from these internally leaked fluids. Properly
dispose of liquid drained from the spill containment in a
manner according to the applicable laws and regulations.
5-6. Meters and Gauges
Engine Meters and Gauges
(1) Hour Meter
Displays the operating time. Use this as a reference for
managing periodic inspection interval.
(2) Tachometer
Displays the engine speed. 3,600 rpm is displayed at 60 Hz.
(3) Fuel Meter
It shows the amount of fuel in the tank.
All lamps are lit when the amount reaches to the maximum
level, and FULL is lit. The lit lamp decreases as the amount of fuel in the tank reaches to
EMPTY.
The fuel level on the control panel will only display the fuel level for the internal fuel tank.
Generator Meters and Gauges
(1) Voltmeter
The voltmeter displays the three-phase output
voltage (voltage between L1-L3). Check that
240 V is displayed during operation. Output
voltage for single-phase three-wire (voltage
between U-W) is the same voltage as the
three-phase output voltage (voltage between
L1-L3). Accordingly, use the voltage meter
displayed value as a reference.
Fuel Meter
Spill Containment Overflow
Warning Indicator
Tachometer
Hour Meter