Shindaiwa DGK125F, Owner'S And Operator'S Manual, Page: 50 / 68

47
Oil Filter
Oil Drain Valve
Open Close
Oil Drain Plug
(1) Engine Oil Replacement
Set a container to catch spilled engine oil.
Remove the oil filler cap.
After removing the oil drain plug and o-ring, open
the oil drain valve and drain the engine oil.
After the oil has been drained,close the oil drain
valve and reinsert the oil drain plug with o-ring.
Add oil through the oil filler until it is at the maximum
level while checking the oil level using the oil level
gauge.
Attach the oil filler cap.
< Note >
 Refer to section “ 8-1. Checking Engine Oil ” for
engine oil replacement amounts and types.
 After reinserting the oil drain plug and shortly after
starting the engine, be sure to always check that there
is no oil leakage.
 Always be sure to wipe up any spilled engine oil.
(2) Replacing the Oil Filter
Replace Every 500 hours
Drain the engine oil.
(Refer to section “(1) Engine Oil Replacement” .)
Remove the oil filter using a filter wrench.
Spread a thin layer of oil on a new oil filter gasket.
Thread the oil filter by hand(do not use a filter wrench), and it
in until the gasket contacts the seal surface, and then tighten
it with one turn using filter wrench.
Add engine oil to the generator.
Shortly after starting the engine, always be sure to check
that there is no oil leaking from the seal surface.
Oil filter cartridge tightening torque
58.8 N ･ m
< Note >
 Request the authorized distributor where the generator was
purchased to perform this procedure if you do not have a
filter wrench.
 Oil filter part no.: 1132402322 (Isuzu part no.)
 Always be sure to wipe up any spilled engine oil.
Replace Every 500 hours
1
2
3
4
5
6
1
2
3
4
5
6
Gasket
Oil Drain Valve
Oil Level Gauge
Oil Filler
Oil Drain Plug