Shindaiwa DGA12DM, Owner'S And Operator'S Manual

Page: 39 / 52

35
Oil Drain Lever
Oil Drain Plug
(1) Change engine oil
Remove the Oil Filler Cap.
Remove the Oil Drain Plug and then turn
The Oil Drain Lever to OPEN and drain engine
oil.
Turn the Oil Drain Lever to CLOSE and tighten
the Oil Drain Plug.
Pour the oil to the upper level, checking. the
height with the Oil Gauge.
Tighten the Oil Filler Cap.
< Note >

For the volume and the type of engine oil to use and
to replace, refer to
『
8-1. Checking Engine Oil
』
.
(2) Oil Filter Change
Drain the engine oil fully, as described in (1) Change Engine Oil.
Loosen and remove the oil filter, using an oil filter wrench.
Smear a little engine oil on the rubber gasket of the new oil filter.
Screw a new filter into place and tighten
it by hand until the gasket contacts the
seat. Then, give it additional 3/4-1 turns,
using an oil filter wrench after the gasket
touch the seal surface.
Supply engine oil.
Initial 50 hours
2
nd
and after Every 200 hours
1
2
3
4
5
Initial 50 hours
2
nd
and after Every 400 hours
1
2
3
5
4
Gasket
Oil Gauge
Oil Filter
Fuel Filter
Oil Drain
Oil Filler (Cap)