Sherwood R-977, Operating Instructions Manual, Page: 75 / 84

Appendix
75
Programming a macro function
The macro function enables you to program a series
of button operations (up to 10) on this remote control
into a single button. You can store up to three
separate macro command sequences into the M1,
M2, and M3 buttons.
1
Press and hold the ENTER button and one of
three NUMERIC buttons (1 ~ 3) simultaneously
corresponding to the M1 ~ M3 buttons for more
than 1 second.
•
If the macro mode is entered, the LED will
flicker once.
GAME AUX CD PHONO
TUNER BD/BDR STB/CBL
F AUX FRBT TV
REPEAT SHUFFLE FAVORITE DELETE
SURROUND STEREO
5 6 7 8
9 0
1 2 3 4
DVD/DVR
10
NET/USB
TEST
DISPLAY
SETUP
DIMMER
ENTER
HOME MENU DISC MENU
RETURN DISPLAY
PURE
AUDIO
MONITOR
SELECT AUDIO SUBTITLE
Example: when programming a series of
button operations into M1 button
2
Press the operation buttons you want to program
in order.
Example: when playing a BD on the
BD player connected to HDMI IN 1
connector of this receiver
1) Press the AVR button to control this receiver.
2) Press the POWER ON button to turn this
receiver on.
3) Press the AVR button to control this receiver.
4) Press the (INPUT SELECTOR) BD button to
select the desired input source.
5) Press the (DEVICE) BD button to control the
BD player.
6) Press the POWER ON button to turn the BD
player on.
7) Press the (DEVICE) BD button to control the
BD player.
8) Press  button to start playback.
POWER ON
POWER ON
AVR AVR 2
BD
BD BD
Note
• You should press the corresponding DEVICE buttons
before pressing each operation button.
3
Press the ENTER button.
• If the programming is performed successfully,
the LED will flicker twice.
SURROUND
TEST
DISPLAY
SETUP
DIMMER
ENTER
HOME MENU DISC MENU
RETURN DISPLAY
PURE
AUDIO
MONITOR
SELECT AUDIO SUBTITLE
STEREO
To remove a macro program

When removing a macro program, perform the
above steps 1 and 3, but skip step 2.
To change a macro program
 When a new macro program is stored into a
MACRO button with performing the above steps 1
to 3, the previous macro program is cleared from
the memory of the MACRO button.
Operating a macro function
1
Aim the remote control at the remote control
sensors of the components to be controlled and
press the MACRO button you want.
POWER ON STANDBY
REMOTE SELECT
TV AVR BD SAT
MUTE
M2 M3 M1
MACRO SLEEP
CH
INPUT
VOLUME ROOM2
Example: when
operating M1 program
M1
Note
• The codes programmed into a MACRO button will
be transmitted at an interval of 0.5 second. However,
some components may not be able to complete one
operation in 0.5 second and may miss the next code.
In this case, the macro function cannot control the
corresponding components correctly.
• Be sure to use the remote control within the remote
control operation range of the components.
• Depending on the operation status of the components,
etc., the macro function may not control the
corresponding components correctly.