Sherwood R-977, Operating Instructions Manual, Page: 58 / 84

OSD Menu Settings
58
4
Press the CURSOR UP(  )/DOWN(  ) buttons
to select the Auto Setup, and then press the
CURSOR RIGHT(

) button.
SURROUND
TEST
DISPLAY
SETUP
DIMMER
ENTER
HOME MENU DISC MENU
RETURN DISPLAY
PURE
AUDIO
MONITOR
SELECT AUDIO SUBTITLE
STEREO SURROUND
TEST
DISPLAY
SETUP
DIMMER
ENTER
HOME MENU DISC MENU
RETURN DISPLAY
PURE
AUDIO
MONITOR
SELECT AUDIO SUBTITLE
STEREO
5
Press the CURSOR RIGHT(

) button to start the
auto setup procedure.
• Loud test tones are output successively and
then if a series of auto setup procedure has
been completed, “COMPLETED” will be
displayed.
• To stop the auto setup procedure while
performing it, press the CURSOR LEFT(

)
button.
•
If there may be a problem with speaker or
microphone connection, error message will
be displayed. In this case, turn off the power,
check the connection and then retry the auto
setup procedure.
SURROUND
TEST
DISPLAY
SETUP
DIMMER
ENTER
HOME MENU DISC MENU
RETURN DISPLAY
PURE
AUDIO
MONITOR
SELECT AUDIO SUBTITLE
STEREO
6
Memorize the results by pressing the CURSOR
RIGHT(  ) button.
•
The results are memorized and the Speaker/
Room EQ Setup menu is displayed.
• When the CURSOR LEFT(  ) button is pressed
to select “CANCEL”, the results are not
memorized.
•
Check the results on each setup menu
(“Speaker Config”, “Speaker Crossover”,
“Speaker Distance” and “Channel Level” menu
for “Calibrate” mode on page 59).
SURROUND
TEST
DISPLAY
SETUP
DIMMER
ENTER
HOME MENU D SC MENU
RETURN D SPLAY
PURE
AUDIO
MONITOR
SELECT AUDIO SUBTITLE
STEREO
7
Disconnect the microphone after you have
completed the auto setup procedure.
Caution
• Because the test tones are loud, ensure there no
infants or young children in the room.
Note
• For best results, ensure the room is as quiet as
possible during the auto setup procedure. If there
is too much ambient noise, the results may not be
satisfactory.
• If the results are not satisfactory, you can retry the
auto setup procedure or personalize your speaker
setup and channel level setup by making the settings
manually. For details, see “Speaker Config”, “Speaker
Crossover”, “Speaker Distance” and “Channel Level”
procedure on page 59.
• After the auto setup has been completed, set the
Room EQ as desired. For details, see “Room EQ” on
page 58.
Room EQ
You can adjust the Room EQ as desired after
performing the Auto Setup procedure.
Menu item Description
On Turn the Room EQ function on
Off Turn the Room EQ function off