SHERCO 2014 250 SE/R, Owner'S Manual

Page: 119 / 194

250-300 SE/R
2
1
1
2 3
Brakes (continued)
Turn off all electric devices and stop the engine.
aTTenTiOn
- 250-300 SE (standard): Confirm that the key start is in
the OFF position.
- 250-300 SE/R (racing): Confirm that the on / off swit-
ch is in the OFF position.
Risk of damage to the CDI.
- Remove the seat (
☛
p.100)
- Remove the air filter (
☛
p.100).
- The battery is located at the bottom of the filter
housing.
- Remove the two screws
1
that retain the
battery retaining bracket.
- Disconnect the negative cable from the battery
2
.
- Disconnect the battery positive cable
3
.
- Remove the battery from the top.
Install the new pads.
Reinstall the retaining pins
2
and clips
1
Check the brake fluid level and fill if necessary.
(
☛
p.114 et p. 116)
aTTenTiOn
Do not use the bike until the brake lever and the pedal
are operational. «Pump» the brake lever / brake pedal
up and down until the brake pads are in contact with
the discs.
reMOving THe BaTTery
electrical system maintenance
118