33
|
P a g e
OPERATION
S
ET THE
T
EMPERATURE
S
ETPOINT
Perform the steps below to adjust the setpoint to your process or application temperature.
End of Procedure
1.
Set the Over Temperature Limit control to its maximum setting, if not already set to max
•
This prevents the heating cutoff system from
interfering with this procedure.
2.
Navigate to the Temperature Setpoint Adjustment mode
Briefly push and release either the
Up
or
Down
arrow
buttons to activate the temperature setpoint adjustment
mode.
•
The display will briefly flash the letters “SP”, then
show the flashing, adjustable temperature
setpoint.
Note:
The display will automatically exit the adjustment mode after 5
seconds of inactivity, with the last shown setpoint value saved.
Setpoint Adjustment
Mode
Initial Setpoint
3.
Set the Temperature Setpoint
Use the
Up
and
Down
arrow buttons to change the
temperature setpoint.
New Setpoint
4.
Wait for 5 seconds after entering the Setpoint
•
The display will stop flashing, and the setpoint is
now saved in the controller.
•
The chamber will now automatically heat or
passively cool to match your setpoint.
•
The display will revert to showing the current
chamber air temperature.
Heating to New Setpoint