30 |
P a g e
OPERATION
Note:
When running the oven at or near its maximum temperature for the first time,
there may be
light smoking
from protective oil coatings on the elements.
P
UT THE
O
VEN INTO
O
PERATION
Perform the following steps and procedures to prepare the oven for use in a new location.
Continued on next page
1.
If this is the first use of the oven, press the red Push to
Reset button to reset the heating element power relays.
•
The oven display will not power up unless the
relays are set.
•
Do not press the gray Reset button on the
controller.
2.
Place the oven
Power Switch
in the on ( I ) position.
The controller display will illuminate and default to its
home page.
3.
10 Minute Minimum
Place the Chamber Under Vacuum
for 10 minutes to verify
the integrity of the vacuum supply system.
See page 33
•
You may leave the chamber under vacuum to
perform the Set the Over Temperature Limit
procedure and the optional temperature
verification procedure.
Summary of Contents for SVAC9-2
