Shel lab SMI11, Installation And Operation Manual, Page: 9 / 36

9 | P a g e
INSTALLATION
I
NSTALLATION
P
ROCEDURE
C
HECKLIST
Carry out the procedures and steps listed below to install the incubator in a new workspace location
and prepare it for use. All procedures are found in the Installation section of this manual.
Pre-Installation

Check that the required ambient condition for the unit are met, page 10

Check that the spacing clearance requirements are met, page 10
•
Unit dimensions may be found on page 33

Check for performance-disrupting heat and cold sources in the environment, page 10

Check that a suitable electrical outlet and power supply is present, page 11
Install the Incubator in a suitable workspace location

Review the lifting and handling instructions, page 12

Make sure the incubator is level, page 12

Install the incubator in its workspace location, page 12
Set up the Incubator for use

Clean and disinfect the unit and shelving (recommended), page 12

Install the shelving, page 13

Verify the port cover has been installed on the access port, page 13