Basic Operation
-25
Turning the Projector On/Off
Connecting the Power
Cord
Plug the supplied power cord into the
AC socket on the rear of the projector.
•
The power indicator illuminates red, and the
projector enters standby mode.
Turning the Projector On
Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 18-25.)
Remove the lens cap and press
ON
on the projector or
ON on the remote
control.
•
The power indicator illuminates blue.
Note
•
About the Lamp Indicator
The lamp indicator illuminates to indicate the
status of the lamp.
Blue:
The lamp is ready.
Blinking in blue:
The lamp is warming up.
Red:
The lamp is shut down abnormally
or the lamp should be replaced.
•
When switching on the projector, a slight
fl ickering of the image may be experienced
within the fi rst minute after the lamp has been
illuminated. This is normal operation as the
lamp’s control circuitry is stabilizing the lamp
output characteristics. This does not indicate
malfunction.
•
If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.
Power cord
Supplied
accessory
Info
•
English is the factory preset language. If you want to
change the on-screen display to another language,
change the language according to the procedure on
page
45
.
Power indicator
Lamp indicator
ON
STANDBY
ON button
Lens cap
STANDBY button
XVZ21000̲E̲Ousyu̲P25-31.indd 25
XVZ21000̲E̲Ousyu̲P25-31.indd 25
2006/07/31 19:54:37
2006/07/31 19:54:37
