Appendix
102
Notes:
• This unit is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, turn off the power and disconnect the unit from
any power sources, including the lithium battery, etc. Then reconnect the power sources to resume
operation.
• If the characters displayed in the viewfinder or on the LCD monitor appear to malfunction, disconnect
the power source and remove the lithium battery, then reconnect the power source, insert the lithium
battery, and turn the power on again. The characters should be normal. Set the date and time, then
resume operation.
Symptom
Cannot rewind or fast
forward tape.
Video noise in image.
Cannot delete image on
card.
Cannot format card.
Cassette will not eject.
No image on monitor.
Viewfinder picture is hard
to see.
Monitor picture is hard to
see.
CHARGE indicator
flashes in red when
charging battery pack.
Cannot edit to connected
VCR.
Remote control does not
function.
Suggested solution
Rewind or fast forward tape to desired
point (
p. 26
).
Call for service (
p. 101
) or use a com-
mercially available cleaning tape (
p. v
).
Use a new cassette.
Cancel the protection setting (
p. 78
).
Contact your dealer for advise.
Connect power source properly (
pp.
10, 11
).
Charge battery pack sufficiently (
p.
9
).
Stop tape and try again (
p. 23
).
Call for service (
p. 101
).
Adjust dioptre (
p. 19
).
Adjust picture (
p. 88
).
Adjust picture (
p. 88
).
Call for service (
p. 101
).
Connect audio/video cable or S-video
cable properly (
p. 64
).
Set REMOTE menu item to “ON”
(
p. 45
).
Replace remote control battery with
new one (
p. 14
).
Use remote control within operating
range (
p. 45
).
Protect remote sensor from exposure
to intense daylight (
p. 45
).
Remove obstacle or use remote con-
trol from different angle (
p. 45
).
CARD mode
VCR mode
General
Possible cause
Position at beginning or end of tape.
Dirty video heads.
Old or worn tape.
Image is delete-protected.
——
Power source is not properly con-
nected.
Battery pack is not charged.
Camcorder is recording.
Fluorescent lamp has burned out.
Viewfinder dioptre is not properly ad-
justed.
Inappropriate picture adjustments.
Inappropriate picture adjustments.
AC adapter or battery pack may have
malfunctioned.
Audio/video cable or S-video cable is
not properly connected.
REMOTE menu item is set to “OFF”.
Remote control battery has run down.
Remote control used beyond operat-
ing range.
Intense daylight falling on camcorder
remote sensor.
Obstacle between remote control and
camcorder remote sensor.
VL-AX1H-097-103
01.11.1, 11:17 AM
102