Remote Operations
41
2. Ans
w
er
ing
Machi
n
e
4
When you have finished listening to your messages, you can do any of
the following:
•
Erase all messages:
Press , ,
and .
•
Repeat playback:
Press
and .
•
Perform other operations:
You can enter any of the commands described
in the following section,
Other remote operations
.
•
Hang up:
If you do not erase your messages first, they will be saved and
any new messages will be recorded after them. If you want the machine to
resume normal operation immediately, press
twice before hanging up
(in some cases, particularly when the Transfer function is used, the
machine may not accept new calls for one or two minutes after you hang up
unless you press
twice).
3
3
7
Note:
You can also call the machine and perform remote operations when the
reception mode is set to FAX. In this case, when you call the machine, press
immediately after it answers (before you hear the fax tone), and then
continue from Step 2 above.
Comments:
♦
When a remote command is accepted by the machine, you will hear one
beep. If an incorrect command is entered, you will hear four beeps. In the
latter case, re-enter the correct command.
♦
When entering a command, do not pause longer than 10 seconds between
each digit. If you do, you will hear a 4-beep error signal and the digits
entered up to that point will be cleared. In this case, re-enter the command
from the beginning.
♦
If you pause for longer than 10 seconds before entering a command, or
make two errors while entering your remote code number, the line will be
disconnected. (This prevents unauthorized people from attempting to
guess your remote code number.)
all.book
Page 41
Tuesday, July 15, 2003
9:53 AM
Summary of Contents for UX-A460
Page 100: ...Index 98 ...