18
E
E
E
E
E
C3. ADAPT BLOWER FOR RECIRCULATION
1.
Remove and save screw that holds blower motor to microwave.
Lift up the blower plate.
Back of
Blower plate screw
Blower motor screw
microwave
Blower motor
2.
Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
BEFORE: Fan blade
openings facing UP
3.
Rotate blower unit 90°.
Before rotation
After rotation
Back of microwave
Back of microwave
4.
Place the blower unit back into the opening.
AFTER: Fan blade
openings facing FRONT
Back of microwave
CAUTION
Do not pull or stretch the blower unit wiring. Make
sure the wires are not pinched.
Note:
The blower unit exhaust openings should match exhaust
openings on rear of microwave oven.
5.
Replace the blower plate in the same position.
STEP-BY-STEP INSTALLATION GUIDE
C4.
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT:
Do not grip or use handle during installation.
If filler blocks are not used, case damage may occur from over
tightening screws.
Note:
If your cabinet is metal, use the nylon grommet around the
power cord hole to prevent cutting of the cord. We recommend using
filler blocks if the cabinet front hangs below the cabinet bottom shelf.
When mounting the microwave oven, thread power cord through
hole in bottom of top cabinet. Keep it tight throughout steps 1 - 4.
Do not pinch cord or lift oven by pulling cord.
1.
Lift microwave, tilt it forward and hook slots at back bottom edge
onto four lower tabs of mounting plate.
2.
Rotate front of oven up against cabinet bottom.
3.
Attach the microwave oven to the top cabinet.
4.
Insert two cabinet mounting bolts (
1
/
4
" x 3" / 0.6 x 7.6 cm) through
outer top cabinet holes. Temporarily secure the oven by turning
the screw at least two full turns after the threads have engaged.
(It will be completely tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially when mounting
flush to the bottom of cabinet.
Nylon grommet
Metal cabinet
Power cord
Power cord
hole
