14
E
E
E
E
E
STEP-BY-STEP INSTALLATION GUIDE
B1.
PREPARE THE REAR WALL TEMPLATE FOR OUTSIDE
BACK EXHAUST
You need to cut an opening (12" x 4" / 30.5 x 10.2 cm rectangular
hole) in the Rear Wall Template for outside exhaust.
1.
Read the instructions on the Rear Wall Template.
2.
Tape it to the rear wall, lining up with the holes previously drilled
for holes A and B in the wall plate.
3.
Cut the opening, following the instructions of the Rear Wall
Template.
B2.
ATTACH MOUNTING PLATE TO THE WALL
Attach the mounting plate to the wall using the wing nuts and toggle
bolts (
3
⁄
16
" x 3" / 0.5 x 7.6 cm). At least one lag screw must be used
to attach the mounting plate to a wall stud.
1.
Insert the toggle bolts (
3
⁄
16
" x 3" / 0.5 x 7.6 cm) into the mounting
plate through the holes designed to go into drywall and attach
the wing nuts to
3
⁄
4
" (1.9 cm) onto each toggle bolt (
3
⁄
16
" x 3" /
0.5 x 7.6 cm).
2.
Place the mounting plate against the wall and insert the wing nuts
into the holes in the wall to mount the plate.
CAUTION
Be careful to avoid pinching fingers between the
back of the mounting plate and the wall.
3.
Tighten all bolts. Pull the mounting plate away from the wall to
help tighten the bolts.
TO USE TOGGLE BOLT
Mounting
plate
Wall
Toggle
Bolt
Wing nut
Bolt end
Spacing for toggles more
than wall thickness
5
/
8
"
B3.
USE TOP CABINET TEMPLATE FOR PREPARATION
OF TOP CABINET
You need to drill holes for the top support screws and a hole large
enough for the power cord to fit through.
• Read the instructions on the Top Cabinet Template.
• Tape it underneath the top cabinet bottom.
• Drill the holes, following the instructions on the Top Cabinet
Template.
CAUTION
Wear safety goggles when drilling holes in the
cabinet bottom.
